Vista 21ip can't get past panel type
Posted: Thu Nov 29, 2018 8:27 pmHi all, first off let me apologize for being a total newbie... 
I just received the AD2Pi Network Appliance and got it all installed and running. I was able to get into the alarmdecoder.local/setup/device on my web browser and have got to the third screen and seem to be stuck. Here's what I have:
Keypad Address
18
AlarmDecoder Address Mask
02000500
Webapp Address Mask
02000501
Zone Expanders
Emulate zone expander #1? yes
Emulate Long Range Radio? yes
When I go to the next screen I get:
Device Testing
Opening device ✔
Saving device configuration ✔
Keypad communication (Send) ✘ Check wiring and that the correct keypad address is being used.
Keypad communication (Receive) ⚠ Test timed out.
I've set up keypad address 18 (*191, 1, 3) on the panel. What am I missing???
I just received the AD2Pi Network Appliance and got it all installed and running. I was able to get into the alarmdecoder.local/setup/device on my web browser and have got to the third screen and seem to be stuck. Here's what I have:Keypad Address
18
AlarmDecoder Address Mask
02000500
Webapp Address Mask
02000501
Zone Expanders
Emulate zone expander #1? yes
Emulate Long Range Radio? yes
When I go to the next screen I get:
Device Testing
Opening device ✔
Saving device configuration ✔
Keypad communication (Send) ✘ Check wiring and that the correct keypad address is being used.
Keypad communication (Receive) ⚠ Test timed out.
I've set up keypad address 18 (*191, 1, 3) on the panel. What am I missing???