I have had my AD2Pi network appliance working with my Vista20p setup since mid-2018 or so and it has been working without much complaint. It was integrated with SmartThings, although it was an arduous process ... mostly because I'm really need that techy.
However, between me messing around with the new SmartThings app and getting my wife (a new member to the hub) added and her account being used on and off with the ST classics app and the new app, I've had to start from scratch ... I've removed all integrated devices and re-added them all back into the Classic app. The only thing that I am still having issues with is my AlarmDecoder setup.
I've re-added all the contacts/sensors back into SmartThings, but for whatever reason, none of them receive any updates (i.e., I open the front door, I walk by motion sensors, etc. ... none of that is recognized in the ST app). These are all recognized on my panel and everything there functions as normal, it just seems like there is a missing link between it and ST.
I've gone through the process of deleting all the devices from the ST classics app, then going to the IDE to perform updates from the repo for the device handlers, etc. and re-installing from the ST classics app again, but still no change. In case anyone asks, yes i did go into the WebApp to obtain the key to input into the classics app.
So unless anyone else has any ideas for me, I was going to attempt a new install on the RPi. Since the last install from 2018, the image for the RPi has since been update a few times so I was hoping this could solve my issues. If there is something glaring that I've missed, please let me know!
