[Solved] What is AD2USB (V2.2a.6) default configuration?
Posted: Wed Feb 19, 2014 10:23 amI just purchased a AD2USB and through trying to connect to it, I ended up changing some of the configuration. Can someone tell me what the default (factory) settings are? Below is the version I have and the present configuration. I think I corrected what was wrong, but not sure. I do have the AD2USB working, but I want to make sure I do not have something set incorrectly. Sorry if this info is posted someplace, but I could not find it. Thanks!
!Ademco Keypad Emulator V2.2a.6
!>Keypad Address (18) :>
!>Config Bits (ff00) :>
!WARNING. Do not enable a module if the physical module exists on the system.
!Zone Expanders Y/N Max allowed: 02
!>expander module #01 ZN 09-16 (N) :>
!>expander module #02 ZN 17-24 (N) :>
!>expander module #03 ZN 25-32 (N) :>
!>expander module #04 ZN 33-40 (N) :>
!>expander module #05 ZN 41-48 (N) :>
!Relay Modules Y/N Max allowed: 04
!>relay module #01 (N) :>
!>relay module #02 (N) :>
!>relay module #03 (N) :>
!>relay module #04 (N) :>
!>Emulate Long Range Radio Y/N: (N) :>
!>Address Filter Mask (afffffff) :>
!>Deduplicate (N) :>
!Reading configuration.
!UART init.
!Ademco Keypad Emulator V2.2a.6
!>Keypad Address (18) :>
!>Config Bits (ff00) :>
!WARNING. Do not enable a module if the physical module exists on the system.
!Zone Expanders Y/N Max allowed: 02
!>expander module #01 ZN 09-16 (N) :>
!>expander module #02 ZN 17-24 (N) :>
!>expander module #03 ZN 25-32 (N) :>
!>expander module #04 ZN 33-40 (N) :>
!>expander module #05 ZN 41-48 (N) :>
!Relay Modules Y/N Max allowed: 04
!>relay module #01 (N) :>
!>relay module #02 (N) :>
!>relay module #03 (N) :>
!>relay module #04 (N) :>
!>Emulate Long Range Radio Y/N: (N) :>
!>Address Filter Mask (afffffff) :>
!>Deduplicate (N) :>
!Reading configuration.
!UART init.