alarmdecoder.com

Hi,

I have AD2USB (hardware with the mini usb port) and upgraded to the firmware V2.2a.6 (V outputs: !VER:00000759,V2.2a.6,TX;RX;SM;VZ;RF;ZX;RE;AU;3X;CG;DD;MF;LR;KE;MK;CB). However I cannot see standard console messages, only messages from the radio (example: !RFX*). Old software was displaying console messages ok, but after having trouble with alarmdecoder python package I've decided to upgrade to newer version to try if this will resolve the problem. All the keyboard have address 31, AD2USB is set to 30:

!>Keypad Address (30) :>
!>Config Bits (ff00) :>
!WARNING. Do not enable a module if the physical module exists on the system.
!Zone Expanders Y/N Max allowed: 02
!>expander module #01 ZN 09-16 (N) :>
!>expander module #02 ZN 17-24 (N) :>
!>expander module #03 ZN 25-32 (N) :>
!>expander module #04 ZN 33-40 (N) :>
!>expander module #05 ZN 41-48 (N) :>
!Relay Modules Y/N Max allowed: 04
!>relay module #01 (N) :>
!>relay module #02 (N) :>
!>relay module #03 (N) :>
!>relay module #04 (N) :>
!>Emulate Long Range Radio Y/N: (N) :>
!>Address Filter Mask (ffffffff) :>
!>Deduplicate (N) :>
!Reading configuration.
!UART init.


Appreciate your help.

Best Regards,
Marcin

Hay Marcin.

If your other keypads are at 31 and function correctly then you must have an SE panel. Set your Ad2* to address 31 and messages should start to show up and you will be able to ARM/DISARM etc.

Re
Sean M