From the WebApp log page:
- Code: Select all
2018-2-7 2:26:20 PM ZONE RESTORE Zone DOOR Basement Utility (15) has been restored.
2018-2-7 2:26:09 PM ZONE FAULT Zone DOOR Basement Utility (15) has been faulted.
2018-2-7 2:26:05 PM DISARM The alarm system has been disarmed.
[entirely missing fault and restore]
2018-2-7 2:25:56 PM ZONE RESTORE Zone DOOR Basement Utility (15) has been restored.
[far too short elapsed time to restore]
2018-2-7 2:25:55 PM ZONE FAULT Zone DOOR Basement Utility (15) has been faulted.
[overly long elapsed time to next fault]
2018-2-7 2:25:28 PM ZONE RESTORE Zone DOOR Basement Utility (15) has been restored.
[inital fault missed]
2018-2-7 2:24:21 PM ARM The alarm system has been armed STAY.
2018-2-7 2:24:11 PM ZONE RESTORE Zone DOOR Basement Utility (15) has been restored.
2018-2-7 2:24:08 PM ZONE FAULT Zone DOOR Basement Utility (15) has been faulted.
2018-2-7 2:23:59 PM ZONE RESTORE Zone DOOR Basement Utility (15) has been restored.
2018-2-7 2:23:53 PM ZONE FAULT Zone DOOR Basement Utility (15) has been faulted.
2018-2-7 2:23:47 PM ZONE RESTORE Zone DOOR Basement Utility (15) has been restored.
2018-2-7 2:23:42 PM ZONE FAULT Zone DOOR Basement Utility (15) has been faulted.
When armed, the initial fault is missing, and seemingly the final fault and restore. Also, the timing looks fine when disarmed, but looks off when armed. Thoughts? Do questions like this belong in the forum, or email to support?
Firmware: V2.2a.8.8
AD2WEB current as of 02-04-2018 10:46:25
Running AD's pre-built Raspian image from 2016-04-29 (plus apt-get update and upgrade and iptables-persistent)
