[Solved] New Install - Unable to send commands

[mhurst]

Hello,

I just installed my first AD2USB. I can see messages form my panel, but I am not able to send commands to the panel.

using the Windows GUI tool I see this in the logs:

DISARMED CHIME Ready to Arm "
12/31/2013 6:43:41 PM [1000000110000000----],008,[f70000031008001c28020000000000]," DISARMED CHIME Ready to Arm "
12/31/2013 6:43:50 PM [1000000110000000----],008,[f70000031008001c28020000000000]," DISARMED CHIME Ready to Arm "
12/31/2013 6:43:57 PM !Sending.done
12/31/2013 6:43:58 PM !Sending.done
12/31/2013 6:43:58 PM !Sending.done
12/31/2013 6:43:59 PM !Sending.done
12/31/2013 6:44:00 PM !Sending.done
12/31/2013 6:44:00 PM [1000000110000000----],008,[f70000031008001c28020000000000]," DISARMED CHIME Ready to Arm "


Any idea why? I am using a Ademco Vista 15P

[mathewss]

It sure looks like its communicating correctly with a "sending.done" What address did you set your AD2* at. Can you confirm no other keypads exist at that same address?

Re
Sean M

[mathewss]

Scratch that its good your panel is talking to addresses 16,25,26

Back to the original question what address is your AD2* set at.


Re
Sean M