SmartThings API Doesn't Discover Device

[BravoCharlie]

Trying to integrate my AD2Pi Network Appliance with SmartThings using the Readme at https://github.com/nutechsoftware/alarm ... martthings

I get down to:
Install SmartApp...Click the Discover button. You'll probably have to hit refresh a couple of times to get your device to show up. If it doesn't show up make sure you're running an up-to-date version of the webapp.

I get: Select device(s) (0 found). Clicking Refresh is not helping. I have WebApp v0.8.0-8-g57438d1. I tried Googling and came up empty. I deleted what had been accomplished in the API under SmartApps up to that point and tried again with the same result.

Unfortunately, my "expertise" ends there. Any ideas or would this be better addressed with the SmartThings community?

Bob

[kevin]

Look at the logs on the pi in /opt/alarmdecoder-webapp/instance/ and /var/log/gunicorn.d and see if the discovery thread started ok.. also make sure you have support for upnp

[BravoCharlie]

It was the UPNP.

Thx,
Bob

[grayzweb]

It was the UPNP.

Thx,
Bob

I'm having same problem. I checked router and UPNP is enabled. What else can I check?

Thanks

[grayzweb]

Look at the logs on the pi in /opt/alarmdecoder-webapp/instance/ and /var/log/gunicorn.d and see if the discovery thread started ok.. also make sure you have support for upnp

I searched event logs in AlarmDecoder web app and could not find either of these entries. ?