How to launch alarmdecoder webapp on pre-config AD2Pi?

[jb170]

I just received the AD2PI appliance with pre-configured image. New to the PI world so feel kinda dumb asking this question but i can't figure out how to launch the alarmdecoder web app on the PI.

Once boot finishes, I'm able to login at 'alarmdecoder login:' with pi, raspberry. I'm stuck at 'pi@alarmdecoder ~$.'

Thanks.

[kevin]

Just point your web browser at the pi's ip address and you'll be good to go!

[jb170]

Thanks. That worked fine.

I used a wired connection to my router to test the connection but would like to install a wifi connection to my Pi. I see that the wifi USB connectors on AlarmDecoder shop are not in stock. Is there a recommended WIFI USB product that is recommended with the AD2PI pre-config?

Also -- i didn't see the set up options for mail in the webapp. Did I miss it? Thanks for the help.

[kevin]

Any of the wifi modules here: http://www.adafruit.com/category/105 should work - you'll just have to shell in and configure it.

Email notifications are under settings -> notifications in the webapp - you create a new notification, and tell it what you want to be notified on and set up email parameters.