Assign a Function Key to a Relay Action

First enter programming mode (Installer Code + 800)

Next enable the relay emulation module you wish to emulate on the AlarmDecoder settings - note emulating relays in existing addresses can cause conflicts.

Only emulate the relay number you need.

Programming

The first step is to assign a function key to a device activation

1. *57
2. Press the function key you want to assign (ex: D)
3. Press * to continue
4. Assign this key to 07 (Device Activation / Change Dev State)
5. Exit

Then you need to map the output.

1. *79
2. Select Output number: 05 (example)
3. Output Type 1 (Relay)
4. Module Addr: 13 (2nd emulated relay on alarmdecoder)
5. Position: 1
6. Exit

Then you need to define the output action

1. *80
2. Select an unused output function number. Example "07"
3. Activate by: Zone Type (2)
4. Enter the Zone Type function key (66)
5. For the Output Action, I've selected close for 2 secs (1)
6. Output Number (I use the same as the Output function number: "07"
7. Exit